Table of Contents
Advertisement
Super X11DSF-E User's Manual
Attaching the Processor Package Assembly to the Heatsink to
Form the Processor Heatsink Module (PHM)
After you have made a processor package assembly by following the instructions on the
previous page, please follow the steps below to mount the processor package assembly onto
the heatsink to create the Processor Heatsink Module (PHM).
1. Locate "1" on the heatsink label and the triangular corner next to it on the heatsink.
With your index finger pressing against the screw at this triangular corner, carefully hold
and turn the heatsink upside down with the thermal-grease side facing up. Remove the
protective thermal film if present, and apply the proper amount of thermal grease as
needed. (Skip this step if you have a new heatsink because the thermal grease is pre-
applied in the factory.)
2. Holding the processor package assembly at the center edge, turn it upside down. With
the thermal-grease side facing up, locate the hollow triangle located at the corner of
the processor carrier assembly ("a" in the graphic). Note the larger hole and plastic
mounting clicks located next to the hollow triangle. Locate another set of mounting clicks
and a larger hole at the diagonal
corner of the same (reverse) side of
the processor carrier assembly ("b"
in the graphic).
3. With the back of the heatsink and
the reverse side of the processor
package assembly facing up, align
the triangular corner on the heatsink
("A" in the graphic) against the
mounting clips next to the hollow
triangle ("a") on the processor
package assembly.
4. Align the triangular corner ("B") at
the diagonal side of the heatsink
with the corresponding clips on the
processor package assembly ("b").
5. Once the mounting clips on the
processor package assembly
are properly aligned with the
corresponding holes on the back
of the heatsink, securely attach the
heatsink to the processor package
assembly by snapping the mounting
clips at the proper places on the
heatsink to create the Processor /
Heatsink Module (PHM).
Non-Fabric CPU and Processor Clip
(Upside Down)
Triangle on the CPU
d
D
Triangle on the
Processor Clip
Heatsink
(Upside Down)
D
On Locations (A, B), the notches
snap onto the heatsink's sides
28
b
c
B
a
C
A
On Locations of (C, D),
the notches
snap onto the heat sink's
B
mounting holes
C
A
Make sure Mounting
Notches snap into place
Advertisement
Table of Contents
