Using A Browser To Control The Projector - Epson PowerLite 4100 User Manual

2. Choose and press
SNMP
3. Turn on the
SNMP
4. Enter up to two IP addresses for notification.
You can enter a number from 0 to 255 in each field of the address.
However, the following IP addresses cannot be used: 127.x.x.x,
224.0.0.0 to 255.255.255.255 (where x is a number from 0 to
255).
5. When you're done making all necessary changes, highlight the
button at the top of the screen, then press
Return
6. If your network environment uses an AMX controller, select
to allow the projector to be detected by AMX Device Discovery.
7. Press to exit.
Menu

Using a Browser to Control the Projector

You can use a standard web browser to monitor and control the
projector through the network.
1. Make sure that the projector is set up for your network, as
described on page 44.
2. Open your web browser and enter the IP address of the projector
you want to monitor in the browser window.
If you're not sure what the address of the projector is, turn the
projector on and select
. You see the following screen:
Enter
setting.
from the Network menu to
Wired LAN
.
Enter
On
note
When using a browser to
access the projector, you
cannot connect through a
proxy server.
Standby Mode in the
Extended menu should be
set to
to monitor the projector in
standby mode.
Using the Projector on a Network
Communication On
49