Epson PowerLite 4100 User Manual page 79

It is time to replace the lamp when:
■ The projected image gets darker or starts to deteriorate.
■ The message
Replace the lamp
lamp comes on.
■ The light flashes orange.
Lamp
To maintain projector brightness and image quality, replace the lamp
as soon as possible.
You may also need to replace the lamp if the
red. See page 87.
Lamp light
Contact your dealer or call Epson at 800-GO-EPSON
(800-463-7766). Request part number V13H010L62 (PowerLite
4100) or V13H010L63 (PowerLite 4200W and 4300).
Follow these steps to replace the lamp:
1. Press the Ppower button on the back of the projector to turn it
off. After the projector beeps twice, unplug the power cord.
2. Let the projector cool for at least an hour (if it has been on). The
lamp is extremely hot immediately after use.
appears on the screen when the
light flashes
Lamp
note
Epson recommends that you
clean the air filter whenever
you replace the lamp.
warning
Let the lamp cool fully
before replacing it.
In the unlikely event that
the lamp has broken, small
glass fragments may be
present and should be
removed carefully to avoid
injury. If the projector has
been installed on the ceiling,
you should stand to the side
of the lamp cover, not
underneath it.
If the lamp is used after the
replacement period has
passed, the possibility that
the lamp may break
increases. When a lamp
replacement message
appears, replace the lamp
with a new one as soon as
possible, even if it is still
working.
Maintaining the Projector
79