Replacing The Paper Cutter Blade; Removing The Used Cutter Blade - Epson Stylus Pro 7000 Printer Manual

Note
If the Ink Out light
remains on, the cartridge
may not be installed
correctly. Remove the
cartridge and then
reinsert it as described
above.
Warning
Be careful not to cut
yourself while replacing the
paper cutter blade.
Caution
To avoid damaging your
printer, never move the
paper cutter holder by
hand.
Maintaining and Transporting the Printer
6. Close the ink compartment cover.

Replacing the Paper Cutter Blade

If you notice that your paper isn't cut cleanly, the cutter blade may need to
be replaced. If you use the blade to cut heavy stock or non-EPSON media,
you may need to replace it more often. You can also check the status of your
cutter by printing the status check sheet or using the Printer Status menu on
the control panel. See page 5-4 or 5-3 for instructions.
To obtain a new cutter blade (part number C815131), contact your dealer.
To replace the cutter blade, you first need to remove the used blade, as
described in the following section.

Removing the Used Cutter Blade

Make sure the printer is on, then follow these steps to remove the blade:
1. Press the
SelecType
appears on the display.
MENU
2. Press the button.
Item
3. Press the button. The paper cutter holder moves to the
Enter
replacement position.
6-9
button repeatedly until
CUT. REPLACE=EXEC.
|
CUTTER REPLACE
appears on the display.
6-9