Ink Cartridge Safety Instructions - Epson Stylus Pro 7000 Printer Manual

If you use an extension cord with the printer, make sure the total ampere
•
rating of the devices plugged into the extension cord does not exceed the
cord's ampere rating. Also, make sure the total ampere rating of all
devices plugged into the wall outlet does not exceed the wall outlet's
ampere rating.
Except as specifically explained in the documentation, do not attempt to
•
service the printer (or RIP Station 5100) yourself.
Power down the printer from the control panel, unplug the printer (or
•
RIP Station 5100), and refer servicing to qualified service personnel
under the following conditions:
If the power cord or plug is damaged; if liquid has entered the printer
(or RIP Station 5100); if the equipment has been dropped or the case
damaged; if the printer (or RIP Station 5100) does not operate normally
or exhibits a distinct change in performance. Adjust only those controls
that are covered by the operating instructions.

Ink Cartridge Safety Instructions

Do not put your hand inside the printer or touch the cartridges during
•
printing.
To avoid damaging the printer, do not move the print head by hand.
•
Under normal circumstances, ink will not come out of the cartridge. If it
•
does get on your skin, wash it off with soap and water. If it gets in your
eyes, flush them immediately with water.
Keep ink cartridges out of the reach of children and do not drink the
•
ink.
Do not dismantle the ink cartridges or try to refill them. This could
•
result in damage to the print head.
Once you install an ink cartridge, do not remove the cartridge except to
•
replace it with a new one.
Install the ink cartridge immediately after you remove it from its
•
package. Leaving the cartridge unpacked for a long time before use may
result in reduced print quality.
Do not use an ink cartridge beyond the date printed on the cartridge
•
package. For best results, use cartridges within six months of installation.
7 7 7 7
Introduction | 7