Epson Stylus Pro 7000 Printer Manual page 98

6-6 | Maintaining and Transporting the Printer
If you're using other media, enter the thickness value of the paper in
0.1-mm increments by pressing the
4. Press the button to save the setting.
Enter
appears on the display.
5. Press the button to print the full series of alignment patterns.
Enter
Each pattern consists of seven numbered rows.
If you want to print a single alignment pattern, press the + + + + or – – – – button
until the pattern number appears. Then press the
After you have printed all the patterns, you need to check them carefully
to determine which row in each set has the smallest gaps. Refer to the
examples shown on page 6-4, then continue with the following steps to
complete the alignment procedure:
6. Examine pattern #1 (or the pattern you printed) and determine which
row of lines has the smallest gaps.
7. Check the control panel display. It should show something like
indicating that row 4 is selected for pattern #1.
8. Use the + + + + or – – – – button to select the best aligned row for pattern #1. Then
press the button to register the setting. The control panel display
Enter
changes to show
#2 = 4
9. Repeat steps 6 to 8 for each pattern you printed. If you need to verify
any of the settings, press
After you have registered all the patterns, press the
head alignment mode and return to normal printer operation.
6-6
or button.
+ –
ADJUST. PATT.= ALL
.
repeatedly to cycle through the patterns.
Enter
button.
Enter
#1 = 4,
button to exit
Pause