Q-Tec Model Nomenclature; Shipping Damage - Bard Q-TEC Q A4D Series Installation Instructions Manual

Q-TEC Model Nomenclature

Q 36
MODEL SERIES
CAPACITY
36 – 3 Ton
42 – 3½ Ton
48 – 4 Ton
A – Air Conditioner
REVISION
SPECIALTY PRODUCTS
D – Hot Gas Reheat Dehumidification
00 – 0kW with Lug Connection
05 – 15kW with Circuit Breaker
See Electrical Specifications for further details.

Shipping Damage

Upon receipt of equipment, the carton should be
checked for external signs of shipping damage. The
skid must remain attached to the unit until the unit is
ready for installation. If damage is found, the receiving
party must contact the last carrier immediately,
preferably in writing, requesting inspection by the
carrier's agent.
A 4 D A 0Z
VOLTS & PHASE
A – 230/208/60/1
B – 230/208/60/3
C – 460/60/3
ELECTRIC HEAT
0Z – 0kW with Circuit Breaker
VENTILATION OPTIONS
X – Fresh Air Damper
B – Blank-off Plate
R – Energy Recovery Ventilator
S – Partial Flow Economizer, JADE
V – Commercial Ventilator, Modulating
Q-TEC GENERAL INFORMATION
X P X X
COLOR OPTIONS
X – Beige Baked Enamel Finish
V – Vinyl Coated
4 – Buckeye Gray Baked Enamel Finish
FILTER OPTIONS
X – 1" MERV 2 Disposable Filter
M – 2" MERV 11 Disposable Filter
N – 2" MERV 13 Disposable Filter
P – 2" MERV 8 Disposable Filter
B – NPBI TECH + 2" MERV 13 Disposable Filter
A – UV-C + 2" MERV 13 Disposable Filter
X X
ACCESSORIES AND CONTROL
OPTIONS
X – Standard Controls
E – Standard Controls, Low
Ambient Control (LAC)
COIL OPTIONS
X – Standard
1 – Phenolic Coated Evaporator
2 – Phenolic Coated Condenser
3 – Phenolic Coated Evaporator
and Condenser
PLACEHOLDER
X – Standard Unit
Q – QSP Plenum Option
Manual 2100-752C
Page 5 of 41