Unit Installation; Wall Mount Products - Mounting The Product On Wall Surface - Bard Q-TEC Q A4D Series Installation Instructions Manual

Installation plays a key part in unit functionality, performance and safety. Product securing and placement, duct
design and supply/return location, electrical routing and condensate and defrost drainage all play key roles in making
sure a unit will perform per the design specifications.
WALL MOUNT Products – Mounting the Product on a Wall Surface
Built-In Mounting Flange Detail:
Outdoor WALL MOUNT products include a
mounting flange that is part of the cabinet
construction. Ø.375" holes are provided for
unit mounting unless specified otherwise in
installation instructions.
Outdoor products are normally mounted to an exterior wall surface, including brick,
cement block, metal or wood construction. These products are labeled as "WALL
MOUNT" units. Before installation begins, the wall surface should be inspected by a
construction professional to ensure it will support the weight of the unit and accessory
items. Approximate weights are available from the product specification sheet, and a
safety factor should be designed into the installation. Typical fasteners to attach the unit
to the wall using the integrated mounting flanges on both sides of the unit include tap
cons, bolts, studs and other fastening devices. The selection of the fasteners to be used
needs to be reviewed by a construction professional and decided upon based on the wall
construction and fastener strength required. It is important to follow all guidelines and
procedures covered in the installation instructions manual provided for the product.
Unit Installation – Wall Mount

Unit Installation

Specification Sheets:
Unit specification sheets provided at
www.bardhvac.com include basic unit weights and
dimensions (see example below). Ventilation options and
other accessories must be added into the total weight of
the unit.
Specification Sheet Example
Manual 2100-034G
Page 5 of 21