Unit Removal From Skid; Air Seal Under Q-Tec Unit; Removal Of Q-Tec Unit From Skid - Bard Q-TEC Q A4D Series Installation Instructions Manual

Unit Removal from Skid

It is not recommended that the unit be removed from
the skid with a fork lift as the air seal under the unit
could be damaged (see Figure 1).
The shipping brackets on each side of the unit must be
removed and discarded (see Figure 2). The return air
grille panel can be removed to provide a place to hold
the unit.
A Shipping Brackets
Manual 2100-752C
Page 6 of 41
FIGURE 1

Air Seal Under Q-TEC Unit

Air Seal
FIGURE 2

Removal of Q-TEC Unit from Skid

B Front Wheels Over Edge
The unit can be tipped forward and slid down the edge
of the skid until the front wheels touch the ground. The
wheels will not roll as they are shipped from the factory
locked. The back of the skid will have to be held down
to keep it from tipping up. The skid can be slid out
from under the unit. The unit can then be set upright.
MIS-1008
C Front Wheels On Floor
Hold Skid
Down
MIS-1007