Finishing Templates - Heat & Glo TRUE-36S-IFT Installation Manual

B. Finishing Templates
Two side fi nishing templates and one top fi nishing
template are supplied with the appliance. Refer to the
decorative front instructions for template removal.
INSIDE FIT Method: The fi nishing template pieces are
required for installations that require more than one inch
thick fi nishing materials to be installed over the face of the
factory-supplied 1/2 inch non-combustible board. Refer
to section 10.D for more information.
OVERLAP Method: The supplied templates are not
required for fi nishing materials less than one inch thick.
The required decorative front will overlap fi nish materials
less than one inch thick. Refer to section 10.D for more
information. Remove template by removing the two top
screws and two screws on each side. The glass assembly
will need to be removed to access the side screws. Follow
the glass removal instructions in Section 11.
Arch Decorative Front Application:
decorative front option is chosen, an Arch Template
Kit is required to be installed prior to the installation of
the decorative fi nishing materials. This kit includes new
fi nishing templates (3) and arch corner fi ll pieces (2).
Contact your dealer to order the correct Arch Template Kit
for your fi replace model.
1-1/4 IN.
Figure 10.2 Top Finishing Template Bend
Heat & Glo • TRUE-36-IFT, TRUE-42-IFT, TRUE-50-IFT Installation Manual • 2461-980 Rev. B • 2/17
If an arch
TAB
Figure 10.3 Left and Right Side Finishing Template Bends
TOP FINISHING
TEMPLATE
SIDE FINISHING
TEMPLATES
Figure 10.4 Top and Side Finishing Template Locations
Note: For Firesceen Fronts (denoted with "FS"), a thin
layer of mortar may be applied over the visible non-
combustible board between fi nishing material and the
fi replace opening.
3/4 IN.
47