Heat & Glo TRUE-36S-IFT Installation Manual page 65

6 6
NOTCH NOTCH
Figure 10.
Log #6 (2282-706): Place Log #6 into appliance as shown in Figure 11. Base of log will sit on bottom refractory and notch
on log will rest against grate tine. Lean top of log into notch on Log #1. See Figure #2.
GROUT LINE #2 GROUT LINE #2
Figure 12.
Log #7 (2281-707): Place Log #7 into appliance as shown in Figure 12. The unburned end of the log should rest on the second
grout line from the front edge. The burned end of the log should rest on the sixth grout line. The right side of the log should contact
the refractory on the right side of the fi rebox.
Log #9 (2170-725): Place Log #9 into appliance as shown in Figure 13. Place log so that the wide end rests on Log #7 and contacts
the refractory on the right side of the fi rebox just in front of the air intake port. The narrow end of Log #9 should contact the rear of
Log #1 and the middle of Log #9 should contact the rear-right vertical grate tine.
Heat & Glo • TRUE-36-IFT, TRUE-42-IFT, TRUE-50-IFT Installation Manual • 2461-980 Rev. B • 2/17
7 7
Figure 11.
GROUT LINE #6 GROUT LINE #6
Figure 13.
LOG RESTS IN NOTCH ON LOG #1 LOG RESTS IN NOTCH ON LOG #1
6 6
LOG CONTACTS LOG CONTACTS
GRATE TINE GRATE TINE
LOG RESTS ON LOG RESTS ON
BOTTOM REFRACTORY BOTTOM REFRACTORY
REAR GRATE TINE REAR GRATE TINE
WIDE END OF LOG WIDE END OF LOG
#9 CONTACTS RIGHT #9 CONTACTS RIGHT
REFRACTORY REFRACTORY
65