Finishing; Facing Material - Heat & Glo TRUE-36S-IFT Installation Manual

10 10

Finishing

A. Facing Material
• Metal front faces may be covered with non-combustible
materials only.
• Facing and/or fi nishing materials must not interfere
with air fl ow through louvers, operation of louvers or
decorative fronts, or access for service.
• Facing and/or fi nishing materials must never overhang
into the glass opening.
• Observe all clearances when applying combustible
materials.
WARNING! Risk of Fire! DO NOT apply combustible
materials beyond the minimum clearances. Comply with
all minimum clearances to combustibles as specifi ed in
this manual. Overlapping materials could ignite and will
interfere with proper operation of decorative fronts and
louvers.
NOTICE: Surface temperatures around the appliance will
become warm while the appliance is in operation. Ensure
finishing materials used for all surfaces (floor, walls,
mantels, etc.) will withstand temperatures up to 190°F.
COMBUSTIBLE MATERIAL
0 IN.
0 in.
NON-COMBUSTIBLE
MODEL
in.
TRUE-36-IFT 61
TRUE-42-IFT 67
TRUE-50-IFT 75
Figure 10.1 Non-combustible Facing Diagram
46 Heat & Glo • TRUE-36-IFT, TRUE-42-IFT, TRUE-50-IFT Installation Manual • 2461-980 Rev. B • 2/17
0 IN.
A
B
BOARD
A B
mm in. mm
1549 57-5/8 1464
1702 62-5/8 1591
1905 66-5/8 1692