Epson LQ-510 User Manual page 206

Options
Problem
Using the pull
tractor with the
push tractor,
continuous paper
does not feed
properly
(continued).
Paper feed is crooked or
the paper jams
(continued).
Several lines
of
occur in the printout.
Skip over perforation is
set, but the skip has
shifted from the
perforation, or the
perforation does not
in the center
fall
skip.
7-30
Troubleshooting
Solution
The paper may be slack. Adjust the
position of the sprockets to take up any
slack along the width of the paper.
Remove slack lengthwise by pressing in
and rotating the pull tractor knob on the
right. Do not turn the platen knob.
The paper thickness lever may not be
correctly set. Set the paper thickness lever
to match the thickness of your paper.
The paper may not meet the
specifications. Check that your paper is
the proper size, weight, and thickness.
space Skip over perforation may be set. Set DIP
switch 2-3 to off.
The loading position of the paper may be
too high or too low. Use the micro-
adjustment feature to reset the loading
position.
the
of