Epson LQ-510 User Manual page 199

Problem
Switching between
single sheets and
continuous paper
cannot be
performed properly
(continued).
Even with the
paper
release lever set
correctly to the single-
sheet position, the
single sheet and
continuous paper feed
together and jam.
The short tear-off
function does not
operate properly.
One page is completely
printed, but the
does not feed.
Printing ended in the
middle a page.
of
Solution
The continuous paper may not have fed
backward far enough to reach the standby
position before you changed
of the paper release lever. Remove the
jammed paper and try again. Also, check
that the
changing the position of the paper release
lever to make sure that the continuous
paper is completely ejected. When there is
more than one page to feed backward to
eject, you must press the
button at least two times.
DIP switch 2-2, short tear-off mode, may
be set to off. Set DIP switch 2-2 to on to
paper
turn on the short tear-off mode.
One page of data may not have been sent
to the printer. Finish, the page by sending
a form feed code (FF) to the printer or by
sending enough line feed codes (LF) to
advance the remainder of the page.
PAPER OUT
light comes on before
Troubleshooting
Paper Handling
the
position
LOAD/EJECT
7-23