Printing
Problem
Printed characters
are not what you
expected.
The typestyle or
characters that are set
by the software cannot
be printed.
The Roman, Sans Serif,
or Draft font is selected
in your software, but
the characters are
printed in a different
font.
Italic characters are
printed instead
selected graphic "line"
characters.
7-8
Troubleshooting
Solution
The software may
installed for your printer. Use the
program's setup (or install) procedure to
check the printer settings, and reset as
needed.
The wrong font is selected. If your
program accepts control codes, set the
codes to the values below to select the
built-in fonts:
Roman:
Sans Serif:
Draft:
See Chapter 3.
The wrong character table is selected. If
your application program is capable of
the
of
sending control codes, specify the Epson
Extended Graphics character table using
ESC t l.
You can also select the graphics character
table by changing a DIP switch setting. To
do this, turn off the power, set DIP switch
1-7 to on, then turn on the printer. See
Chapter 3.
be correctly
not
ESC
k
ESC
k
ESC
x
0
1
0