Using Multi-Part Forms - Epson DFX-9000 Reference Manual

Using multi-part forms

You can use multi-part (carbonless or carbon-backed) forms
with up to seven sheets, including the original, on the rear
tractor. On the front tractor, you can use forms with up to ten
sheets.
You load continuous multi-part forms the same way you load
any other type of continuous paper. Before loading multi-part
forms, however, make sure the paper has a clean straight edge
and does not separate or tear apart. See "Loading Paper Onto
the Front Tractor" on page 15 or "Loading Paper Onto the Rear
Tractor" on page 22 for instructions.
The DFX-9000 can print on multi-part forms that vary in
thickness, such as forms with labels on them or forms that
overlap slightly where they are glued together. These forms are
thicker in the label area and in the places where they overlap or
are joined together, as shown below. Before you print on forms
with labels, use SelecType to make sure the Forms w/labels
setting is set to On. When you use overlapping multi-part forms,
set the Overlapping multipart forms setting to On and the
Platen gap setting to 0 to 14, depending on the paper thickness
you are using. See "Changing the settings in SelecType mode"
on page 94 for details.
Overlapping multi-part forms
Continuous forms with labels
Paper Handling
2
2
2
2
2
2
2
2
2
2
2
41