Setting Lj4 Emulation Options - Epson ColorPage 8000 Printer Manual

Note
Font pitch and height
depend on the font
selected. Available
symbol sets also depend
on the fonts installed.

Setting LJ4 Emulation Options

The LJ4 menu lets you make font and symbol settings when you use the
printer in LJ4 emulation mode. Normally you can make these settings
through your software. You only need to use these settings if you are using
software that can't control fonts.
LJ4 menu settings
Setting Options
Font Source Resident, DIMM,
Download
Font Number From 0 upwards
(maximum value =
65535)
Pitch 0.44 to 99.99 cpi in
steps of 0.01 cpi;
default is 10.00
Height 4.00 to 999.75 pt in
steps of 0.25 pt
SymSet 32 symbol sets plus
19 international
variations of the
Roman 8 set
Form 5 to 128; default
is 60
Source 0 to 3199
SymSet
Dest SymSet 0 to 3199
3-13
Configuring the Printer
Description
Selects the source of fonts used for
printing; DIMM selects fonts in
memory.
Selects the font for the print job. You
can print a font sample sheet (Test
Menu) to determine the font numbers.
Selects the pitch (the horizontal
spacing) of the font used in the print
job, if the font is scalable and is
fixed-pitch. The font pitch is expressed
in cpi (characters per inch).
Selects the height of the font used in
the print job, if the font is a proportional
scalable font. The height is expressed
in points.
Selects the symbol set of the font
used in the print job.
Sets the number of lines for the
selected paper size and orientation.
This causes a line spacing (VMI)
change, which is stored in the printer.
Any later changes in the Page Size or
Orientation settings cause changes to
this Form value, based on the VMI
settings stored here.
You can only make these settings if an
optional font ROM has been installed.
| 3-13