Warning
Be careful when working
inside the printer as some
pieces are sharp and may
cause injury.
Caution
Make sure you insert the
contact side of the
module into the slot as
shown. Do not apply
force.
4. Open the front of the cover until the pin comes out of the hole. Then
remove the cover by sliding it back.
5. Locate the two available memory module slots. Make sure the clips at
the sides of the slots are open.
open memory
module slots
6. Insert the module into either slot, with the gold contact side of the
module leading into the slot. Then snap the clips against the module.
A-3
Installing Options
|
A-3