Example Of Programming Functions .19 & .2 (Sp2) - Omega CN9000A Series User Manual

3.5.1.2 Example of Programming Functions .19 & .2 (SP2)
When using SP2 as a tracking second setpoint (deviation from first
setpoint): Function .19, Options 1, 2, 3, or 7 will enable the second
setpoint and Function .2 is to be used to set the differential value
between the first and second setpoint.
STEP
The following steps apply to Function .2. Function .19 must be set
up before setting Function .2.
Ensure that the jumper behind
1
the lower front bezel is in the
Parameter Setting position
(the jumper should be on the
two right-most pins). Refer to
Section 3.13 if necessary.
To convert the main display
2
from a temperature read-out
to the Function/Option Mode:
To change from Function .0 to
3
Function .19:
To display Option:
4
To change Option value (refer
5
to Table 3-4); for example, 7:
6 To change to Function:
20
NOTE
ACTION
Press P
Option 0
Function .0
(flashing)
Press
until you see 0.19
Function (flashing)
Press ★
Option (flashing)
Press
increase (or
to decrease
depending on
Option value)
Flashing
Press ★ Function
(flashing)
DISPLAY
0.
0.
7.
to
7.
0. 0
1 9
1 9
1 9
1 9