Enterasys Aurorean ANG-3000 Installation & Service Manual page 49

Chapter 3
Installing Software & Setting Networking Configurables
Aurorean Installation & Service Guide
4 When the dialog box prompts you to reconfigure your APS, click Yes.
An MS DOS screen appears displaying a Perl script as shown in
Figure 26.
Figure 26 APS Perl Script Screen
5 As prompted, replace the factory default values with the following
new parameters. Consult your VPN Configuration Worksheet as
needed.
– VPN Name - Designation of the VPN system
– IP address - IP address of the APS
– Subnet Mask - Subnet mask of the APS
Default Gateway - IP address of the gateway on the APS network
–
– Hostname - Designation of the APS
– DNS Domain Name - Name of the DNS Domain where the APS
resides
6 Type y to write this data to the database.
7 When prompted, press
8 When the Update Service pop-up window appears, click OK.
9 When the Setup Complete window appears, click Finish to complete
the installation and reboot the APS.
Installing APS-3000/7000 Software
.
ENTER
35