Enterasys Aurorean ANG-3000 Installation & Service Manual page 108

Checking LEDs
Table 1 APS/ANG-3000/7000 Front Panel LED Meanings (Continued)
This LED... Indicates...
This LED lights when a
Yellow
successful 100Mb link is
successful on the Trusted
Link 1
Ethernet port.
The operating system has
booted and the Overlord
service is running.
Controller detects and
Green
configures for 100Mb
operation.
Speed
LAN #1
This LED lights when a
Yellow
successful 100Mb link is
successful on the External
Link 2
Ethernet port.
Controller detects and
Green
configures for 100Mb
operation.
Speed
LAN #2
The system has contacted
Green
another Aurorean system and
is able to exchange
U1
management messages with
Link
that system (indicating that a
Delivery service session is up
and the other system is
considered reachable).
94
When
the LED Do the following...
is...
On and No action required.
blinking
Off Press the Reset button to reboot the system.
If the LED stays off after rebooting, connect a
keyboard, monitor, and mouse to the system
and contact Enterasys Networks Customer
Support as described in Appendix C.
On No action required.
Off Link on Trusted Ethernet port is configured
for 10Mb.
On and No action required.
blinking
Off Verify that the power cord is plugged into a
functional wall outlet or UPS and into the
receptacle on the system's rear panel.
On No action required.
Off Link on External Ethernet port is configured
for 10Mb.
On No action required.
Off Check the Ethernet ports and LEDs on the
system rear panel to ensure the cables are
securely connected and that the Ethernet
link is active. Using the RiverMaster
management application, check the
IP addresses assigned to each Ethernet port
and verify that any routers or firewalls
separating the systems are configured to
pass packets between the addresses.
Basic System Operation
Aurorean Installation & Service Guide
Chapter 4