Bosch MUM59 GB Series Instruction Manual page 16

en Bowl and tools
■ Take the tool out of the drive.
■ Remove the bowl.
■ Clean all parts, see "Cleaning and
servicing".
Continuous-feed shredder
Observe the application examples in table M
W Risk of injury
Do not grip the sharp blades or edges of the
cutting discs. Take hold of cutting discs by
the edge only. Before attaching / removing
the continuous-feed shredder, wait until the
drive has come to a standstill and pull out the
mains plug. Do not reach into the feed tube.
Warning!
The continuous-feed shredder must be
completely assembled before use. Never
assemble the continuous-feed shredder on
the base unit. Operate the continuous-feed
shredder in the indicated operating position
only.
Predetermined breaking point
Figure F:
The built-in predetermined breaking point
protects the drive of the appliance. If an
overload occurs, the drive shaft of the
continuous-feed shredder breaks. However,
the drive shaft can easily be replaced.
A new disc holder with drive shaft is available
from customer service.
Professional Supercut
reversible disc –
coarse / fine
for cutting food into thick or thin slices, e.g.
fruit and vegetables.
Marking:
■ Grob = thick slices
■ Fein = thin slices
Note: Not suitable for processing hard
cheese, bread, rolls or chocolate.
Tip: Only cut up cooked potatoes once they
have cooled down.
16
Reversible shredding disc –
coarse / fine
for shredding food coarsely or finely, e.g.
fruit, vegetables or cheese as Gouda or
Edam.
Marking:
■ 2 = coarse side
■ 4 = fine side
Note: Not suitable for processing nuts or
hard cheese, e.g. Parmesan.
Tip: Shred soft cheese with the coarse side
only.
Fine grating disc
for shredding food finely, e.g. nuts or
hard cheese such as Parmesan.
Note: Not suitable for processing soft
cheese and cheese slices.
Grating disc – coarse
for grating raw potatoes, e.g. for
potato pancakes or dumplings.
Asia vegetables disc
for cutting food into thin strips, e.g.
fruit and vegetables.
Working with the continuous-feed
shredder
Figure G:
■ Press the Release button and
move the swivel arm to
position 2.
■ Insert the bowl:
– Tilt the bowl forwards and then set it
down.
– Turn anti-clockwise until it locks into
place.
■ Press the Release button and
move the swivel arm to
position 3.
■ Remove drive cover from the
drive of the continuous-feed shredder
(Fig. G-5a).
■ Hold disc holder at the lower end,
ensuring that the two tips are face up.