Using The Reset Switch; Reset Switch - Enterasys SecureStack B2 B2G124-48P Hardware Installation Manual

Using the Reset Switch

If you forget the switch login password, use the Reset switch as described in the following
procedure.
Figure 4-24

1 Reset switch

To reset the switch password, refer back to Figure
1. Press‐and‐hold the Reset switch while the switch device is operational. This change of
the login password to the default password will be indicated through CLI only.
2. Logon to device management. You can now logon to the switch through the Console
port and assign a new password using the command line interface (CLI).
3. To access switch management from your local PC, terminal, or modem connection,
refer to the SecureStack B2 Configuration Guide for instructions on how to log in and
enter a new password. The guide is available at:
http://www.enterasys.com/support/manuals
If you require assistance, contact Enterasys Networks using one of the methods described
in "Getting Help" on page 1‐8.
Reset Switch
Note: Notify the system manager before changing the password.
Using the Reset Switch
À
4‐24 and proceed as follows:
SecureStack B2 Installation Guide 4-9