High-Speed Stack Connections; B2H124-48P Stackable Switch - Enterasys SecureStack B2 B2G124-48P Hardware Installation Manual

Overview
The 10/100 Mbps fixed front panel ports can operate in either half‐duplex or full‐duplex
mode, as determined by Auto‐Negotiation.
Figure 1-2
Á
1 DB9 RS232 console port connector
2 System status LEDs
3 Forty-eight RJ45, 10/100 Mbps, PoE ports
4 RJ45 port status LED
5 Four slots for SFP interface modules
(Mini-GBICs)

High-Speed Stack Connections

The switches have rear‐panel connectors for high‐speed connections in a stack
configuration. The high‐speed stacking cables used for the connections are optional items
and must be ordered separately. Stacking cables are available in three lengths: 1 foot,
1 meter and 5 meters. See "Connecting High‐Speed Stacking Cables" on page 3‐10 for
details on these cables.
1-4 Introduction
Caution: The C2RPS-POE power supply does not support non-PoE compliant
SecureStack C2 switches. Do not try to connect the power cable from this C2RPS-POE
power supply to any SecureStack C2 switch that does not have a "P" suffix in the model
name. (Example: C2G124-24.) Otherwise, damage to the device may result.
Precaución: La fuente de poder C2RPS-POE no es compatible con switches
SecureStack C2 que no cumplan con el estándar PoE. No intente conectar el cable de
corriente de esta fuente de poder C2RPS-POE a ningún switch SecureStack C2 que no
tenga el sufijo "P" en el nombre del modelo. (Ejemplo: C2G124-24.) De lo contrario, el
dispositivo puede dañarse.

B2H124-48P Stackable Switch

Æ Ç
S
Ã
Â
È
6 Mini-GBIC port status LEDs
7 Two ports for stack connections
8 Password Reset switch
9 AC power input connector
10 RPS connector for C2RPS-POE
redundant power supply connection
Å
Ä À
É