Connectivity; Management; Switch Configuration Using Webview; Switch Configuration Using Cli Commands - Enterasys Matrix 7H4284-49 Hardware Installation Manual

Dfe-platinum series

Hide thumbs Also See for Matrix 7H4284-49:

Table of Contents

Connectivity

Network Expansion Module Option

The 7H4284-49 option slot provides access to an installed network expansion module. Refer to the

Enterasys Networks web site for a current listing of the available NEMs. Specific installation

instructions are shipped with each NEM.

1.2

CONNECTIVITY

The 7H4284-49 supports 48, 100BASE-FX switched multimode fiber-optic ports connected via 48

fixed MT-RJ front panel connectors. If a NEM is installed, additional connectors are also

available, depending on the NEM model.

The 7H4284-49 can be installed in a Matrix N1, Matrix N3, Matrix N5, Matrix N7, or Matrix E7

chassis, but only supports FTM2 data backplane interconnections in the Matrix E7 chassis.

Interconnection from FTM2 to FTM1 can only be accomplished using an FTM bridging module

such as the 7H4382-25, 7H4382-49, 7H4383-49, or 7H4385-49 DFE module.

1.3

Management of the module can be either in-band or out-of-band. In-band remote management is

possible using Telnet, Enterasys NetSight

Out-of-band management is provided through the RJ45 COM (Communication) port on the front

panel using a VT100 terminal or a VT100 terminal emulator.

1.3.1

Enterasys Networks' HTTP-based Web management application (WebView) is an intuitive web

tool for simple management tasks.

1.3.2

The CLI commands enable you to perform more complete switch configuration management

tasks. For CLI command set information and how to configure the module, refer to the Enterasys

Matrix DFE-Platinum Series Module Hardware Installation Guide.

1-4

Introduction

management application, or WebView™ application.

Table of Contents