Dimm Replacement Procedure; Removing The Existing Dimm; B-5 Installing The Dram Simm - Enterasys Matrix 7H4284-49 Hardware Installation Manual

Memory Locations and Replacement Procedures
Figure B-5 Installing the DRAM SIMM
1 Connector arms
2 DRAM SIMM memory module
B.3.3

DIMM Replacement Procedure

In the event that the DIMM needs to be replaced, the following sections explain how to remove
and install the DIMM. If you have questions concerning the replacement of the DIMM, refer to
"Getting Help" on page xviii for details on how to contact Enterasys Networks.
Removing the DIMM
Note: To access and remove a DIMM, you may need to remove the optional network
expansion module (NEM), if one is installed in your DFE module. To remove the NEM,
refer back to the instructions in the section,
page B-5
Caution: Observe all antistatic precautions when handling sensitive electronic
equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las
precauciones de seguridad para evitar descargas de electricidad estática.
To remove the existing DIMM, proceed as follows:
1. Locate the DIMM connector on the main PC board. Refer back to
location on the 7H4284-49.
B-8 Mode Switch Bank Settings and Optional Installations
À
.
Ã
Á
Â
3 Connector fingers
4 Alignment notches (2)
"DRAM SIMM Replacement
Ã
À
Figure B-2 for the DIMM
Procedure" on