Viessmann Vitocell 140-E Installation And Service Instructions For Contractors page 18

Installation sequence
Vitocell without fitted Solar-Divicon
Fitting the cover strip
2.
A Type plate (self-adhesive)
1. Tighten the nuts on the bolts.
2. Trim and fit the cover strip.
3. Insert the rear sections of the
Vitotrans thermal insulation. Observe
the groove in the thermal insulation.
18
3.
1.
4.
4. Fit the front section of the Vitotrans
5. Push the cylinder thermal insulation
(cont.)
7.
6.
thermal insulation.
towards the front by patting it. This
reduces the gap between the
Vitotrans and the cylinder.
A
5.