Graco Ex35 Installation Manual page 5

ELECTRIC ELECTRIC ELECTRIC SHOCK
This equipment must be grounded. Improper grounding, setup, or usage of the system
can cause electric shock.
• Turn off and disconnect power at main switch before disconnecting any cables and
before servicing or installing equipment.
• Connect only to grounded power source.
• All electrical wiring must be done by a qualified electrician and comply with all local
codes and regulations.
• Do not expose to rain. Store indoors.
• Wait five minutes before servicing after power is removed.
BURN HAZARD
BURN BURN
Equipment surfaces and fluid that is heated can become very hot during operation. To
avoid severe burns:
• Do not touch hot fluid or equipment.
MOVING PARTS
MOVING MOVING
Moving parts can pinch, cut or amputate fingers and other body parts.
• Keep clear of moving parts.
• Do not operate equipment with protective guards or covers removed.
• Pressurized equipment can start without warning. Before checking, moving, or servicing
equipment, follow the Pressure
SKIN SKIN SKIN INJECTION
High-pressure fluid from gun, hose leaks, or ruptured components will pierce skin. This
may look like just a cut, but it is a serious injury that can result in amputation. Get
immediate surgical
immediate immediate
• Do not spray without tip guard and trigger guard installed.
• Engage trigger lock when not spraying.
• Do not point gun at anyone or at any part of the body.
• Do not put your hand over the spray tip.
• Do not stop or deflect leaks with your hand, body, glove, or rag.
• Follow the Pressure
checking, or servicing equipment.
• Tighten all fluid connections before operating the equipment.
• Check hoses and couplings daily. Replace worn or damaged parts immediately.
3A3165H
WARNING WARNING WARNING
SHOCK HAZARD SHOCK HAZARD HAZARD
HAZARD
HAZARD
PARTS HAZARD HAZARD
PARTS HAZARD
Pressure Relief
Pressure
INJECTION HAZARD INJECTION HAZARD HAZARD
surgical treatment. treatment.
surgical treatment.
Pressure Relief Pressure Relief Procedure Relief
Relief Procedure Procedure and disconnect all power sources.
Relief Procedure
Procedure when you stop spraying and before cleaning, Procedure
Warnings
Get Get
5