Table of Contents
Advertisement
Adjuster "ADJUSTER"
Steering stick and throttle stick neutral position and servo operating angle correction
can be applied. This is used when a mechanical offset has occurred for some reason.
*However, when correction is made, the set value of all the setting functions must
be rechecked.
Display the adjuster screen from the system menu.
(MENU 1 screen)
(HOME screen)
Press
Steering adjustment
(Preparation)
On the ADJUSTER screen, select the setting item "Steering"
using the (JOG) button, and pressing the (JOG) button.
1
(Steering neutral adjustment)
In the neutral setup screen (fig-1) state, pull the stick back
slightly then allow to return to neutral and press the (JOG)
button whilst ensuring the stick is not touched.
2
(Steering throw adjustment)
In the throw setup screen state (fig-2), lightly turn the stick
fully to the left or right and when button mark (fig-3) is dis-
played, pressing the (JOG) button.
Internal check is performed automatically. When each adjust-
ment point is within a fixed range, correction is performed
and "COMPLETE" (fig-4) is displayed.
If an adjustment point is not within a fixed range, correction
is not performed and the correction data is not updated.
When button mark is not displayed even though correction
was performed again, please contact a Futaba Radio Control
Customer Center.
3
When completed, return to the MENU2 screen by pressing
the (JOG) button.
(MENU 2 screen)
Select
Press
"ADJUSTER"
Adjuster "ADJUSTER"
(ADJUSTER screen)
ADJUSTER
[
RT
]
＊STEERING
＊THROTTLE
Press
Press
fig-1
fig-2
fig-3
fig-4
113
Advertisement
Table of Contents
