Table of Contents
Advertisement
2
(Recording cycle setting)
Select the "CYCL" setting item using (JOG)
button up or down operation, and set the data
acquisition interval from a minimum 0.1 sec-
ond to a maximum 60 seconds with the (+)
button or (-) button.
The maximum recordable time set by CYCL is
displayed at END TIME shown below.
3
(Count alarm ON/OFF)
Select the "ALRM" setting item using (JOG)
button up or down operation. To sound an
electronic beep at each log count, set "ALRM"
to ON with the (+) button or (-) button.
"OFF" : Alarm OFF
"ON"
: Alarm ON at each log count
When completed, move the cursor to [RT] using the (JOG)
button, and return to the HOME screen by pressing the (JOG)
button twice.
Log function start/stop operation
1
(Log start operation)
-Start by switch (SW1)
When the switch (SW1) set by SW/dial func-
tion is pressed, data logging starts.
-Starting by throttle stick
Display the log setting (LOG MODE) screen
and select the "STATE" setting item using
(JOG) button up or down operation, and press
the (JOG) button for approximately 1 second.
An electronic beeping sound is generated and the "STATE" display switches from "RST"
to blinking "RDY", and the logger enters the stick operation wait state. When the stick
is operated in the forward direction, data logging begins. (STATE display "STA") When
the end time arrives, an electronic beep sounds and data logging stops. To return to the
HOME screen during data logging, move the cursor to [RT] using (JOG) button up or
down operation, and press the (JOG) button or (+) button.
2
(Log forced end)
To abort logging, press the switch (SW1), in the same way as starting, or display the log
setting (LOG MODE) screen and select the "STATE" setting item using (JOG) button up
or down operation and press the (JOG) button for approximately 1 second. An electronic
beeping sound is generated and logging is stopped.
Telemetry "TELEMETRY"
Log recording cycle
0.1~60s(
)
sec
0.1~10s(
sec
)0.1s step
10s~60s(sec)1s step
Initial value: 1.0
sec
Adjust button
- Adjust with the (+) and (-) but-
tons.
- Return to the initial value "0" by
pressing the (+) and (-) buttons
simultaneously for about 1 sec-
ond.
Log recording time
20s ( s e c o n d s ) ~3h 20m (3
hours 20 minutes)
The maximum recordable time
set by CYCL is displayed auto-
matically.
Alarm ON/OFF
ON, OFF
- Select with the (+) or (-) but-
tons.
Status display
RDY :Throttle stick operation wait
STA :Logger running
STP : Logger stopped
121
Advertisement
Table of Contents
