Table of Contents
Advertisement
ESC Link Function "MC LINK"
This is a special function which lets you set the contents of the Link software in
Futaba speed controller (ESC), MC960CR, MC940CR, MC950CR, MC851C,
MC602C, MC402CR, etc, with variable frequency and other data changes at the
T4GRS transmitter. However, some data changes require a PC and Link software.
This function is used by connecting ESC directly to the transmitter. The T4GRS
power switch is set to the display side. Use the various optional servo extension
cords according to the distance between the transmitter and ESC. The last data read
from ESC to T4GRS or the last data written from T4GRS to ESC is saved to the
T4GRS. Since the data for each model memory can be saved, the data of up to 40
models can be saved.
-When the T4GRS battery voltage drops, the display switches to low battery display. Therefore, use this function when there
is ample battery capacity remaining.
-Also connect the battery at the ESC side.
-Note: Do not read to the T4GRS an MC940/960CR whose speed was set to over 99990rpm by Link software side Boost
Angle rpm setting.
(DISP MENU screen)
Using the ESC Link function
(Preparation)
-Connect the T4GRS and ESC in accordance with the connection
diagram, and connect the battery to ESC.
1
Set the transmitter power switch to the display side (DISP).
Display the MC LINK function screen in the above manner.
2
(ESC read)
Execute this function to read the connected ESC type and the data currently set at the
amp. To save the ESC data to the T4GRS, rewrite the read data.
When you want to write the data saved in the T4GRS to an ESC of the same type, ex-
ecute the following "WRITE"(write) without executing "READ"(read).
92
Connection diagram
(MC LINK screen)
Select
"MC LINK"
Press
Press
ESC Link Function "MC LNK"
ESC receiver connector
Communication port
Connecting ESC receiver
connector to the transmitter
Communication port
MC402CR
MC602C
MC851C
MC960CR
MC950CR
MC940CR
Advertisement
Table of Contents
