SATO TG3 Series Quick Manual page 26

(1) Small stacker (STS302)
(2) Large stacker (ST-TG3)
(3) External rewinder (RWG500)
Options (4) External rewinder (RW350)
(5) RFID kit (HF band specification/UHF band specification)
(6) Simple input device (Keypad)
(7) Ribbon core compatibility kit
(1) Communication interface (1 slot)
Interface board (2) External connector (for optional devices)
(3) RS-232C D-sub 9-pin type (for simple input device (Keypad) only)
(1) RS-232C (high-speed) interface board
(2) IEEE1284 (ESP/compliant) interface board
(3) LAN interface board
Optional communication
(4) Wireless LAN interface board *
interface boards
(5) USB interface board (FULL SPEED compatible)
LCD specifications Graphic LCD (128×64 dots) with side light
Operation keys Online, Feed/OK, Cutter ON, Eject Cut, Setting Mode, Select Paper, Orientation (4)
(1) Paper gap adjustment
(2) Pitch sensor level adjustment
(3) I-mark sensor level adjustment
(4) Gap sensor level adjustment
Level adjustment
(5) Ribbon sensor level adjustment
(6) Print density adjustment
(7) Side hole sensor level adjustment
(8) Notch sensor level adjustment
(9) Jump hole sensor level adjustment
(1) I-mark sensor (reflective type)
(2) Gap sensor (transmissive type)
(3) Center hole sensor
Detection sensors
(4) Side hole sensor
(5) Notch sensor
(6) Jump hole sensor
* Wireless LAN IEEE802.11b/g
The board comes with a wired LAN connector. However, the simultaneous use of a wireless connection and wired connection is not possible.
Notice About Registrations and Trademarks of Other Companies' Products
QR code is a registered trademark of Denso Wave Incorporated.
26