Summary Of Components - Skoda FABIA 2000 Workshop Manual

17

Summary of components

1 - Cap
fit on during installation work
2 - Gasket
replace if damaged
on the engine cover
3 - 0.9 bar (0.09 MPa) oil pres-
sure switch - F1-, 45 Nm
grey
inspecting ⇒ Chapter 17-3
cut open seal if leaking and
replace
4 - Oil filter
slacken with tensioning strap
moisten seal with oil
tighten by hand
pay attention to installation
instructions on oil filter
pay attention to change inter-
vals
5 - Split pin
6 - Ball
for pressure relief valve
when installing, knock in
slightly with aluminium drift
so that the seat of the ball is
smoothened
7 - 40 Nm
8 - Pressure spring
for pressure relief valve
9 - 8 Nm
10 - Intermediate plate
clamped onto oil pan support of 1.4 ltr. engine
11 - Oil pan support
for 1.4 litre engine only:
12 - Bracket
for middle coolant pipe
for 1.0 ltr. engine only: 2 bolts M6x22 (different colour and shape); do not mix up with other bolts (M6x20)
13 - 10 Nm
14 - 20 Nm
15 - 45 Nm
for 1.4 litre engine only:
16 - Oil drain plug, 30 Nm
17 - Gasket
replace
18 - Oil pan
removing and installing ⇒ Chapter 17-2
19 - Gasket
for 1.0 litre engine only
replace
coat the joints between the timing gear cover/cylinderblock with sealant -AMV 188 520- before installing the
oil pan with gasket ⇒ Fig. 3 in 17-1 page 4
20 - 8 Nm
17-1 2
page
FABIA 2000 1.0/37; 1.4/44; 1.4/50 Engine, Mechanical Components
Removing and installing parts of the lubrication system
S17-0081
Edition 02.02
S00.5305.03.20