Inspecting Synchronous Running Of Sprockets - Skoda FABIA 2000 Workshop Manual

FABIA 2000 1.0/37; 1.4/44; 1.4/50 Engine, Mechanical Components
Modifications of the 1.0 litre engine compared to the 1.4 litre engine
1 - Bearing caps
Bearing cap 1: on the belt
pulley side
Bearing cap 2: with recesses
for thrust washers
2 - Bearing shell
for bearing cap without lubri-
cating groove
do not mix up used bearing
shells (mark)
3 - Thrust washer
for bearing cap 2
check for firm seating
4 - Crankshaft
Axial play when new: 0.03 to
0.13 mm
Wear limit: 0.26 mm
5 - Bearing shell
for cylinder block with lubri-
cating groove
do not mix up used bearing
shells (mark)
Fig. 1: Camshaft setting
–
Insert chain sprockets -2- and -3- into the timing chain
-1- so that the distance -a- (from marking to marking
-arrows-) is 12 chain pins.
Inspecting synchronous running of
sprockets
This inspection should be carried out if the sprockets
have been replaced.
Special tools, test and measuring equipment and
auxiliary items required
♦ Straightedge
♦ Feeler gauge
The crankshaft sprocket is available in 3 different widths;
graduations: marked 0.2 mm with letters „E", „F" or „G".
The wheel with an average thickness, marked with the
letter „F", is supplied together with the camshaft sprocket
Edition 09.03
S00.5305.04.20
Disassembling and Assembling Cylinder Block and Crankshaft
1
2
3
4
5
S13-0209
1
2
S15-0028
3
13-2
page
13
3