Setting The Visual Button; Changing The Lighting Colour Of Buttons; Subwoofer On And Off; Setting The Digital Output - Alpine IVA-D105R Owner's Manual

Setting the VISUAL Button

Setting item: VISUAL KEY
Setting content: VISUAL / NAV.
NAV.: Switches directly to the navigation screen by pressing
VISUAL. (Only when an Alpine optional RGB
Navigation is connected.)
VISUAL: Recalls the VISUAL Select screen by pressing
VISUAL.

Changing the Lighting Colour of Buttons

Setting item: ILLUMI. COLOR
Setting content: BLUE / RED
BLUE: Lighting colour is blue.
RED: Lighting colour is red.

Subwoofer On and Off

Setting item: SUBW. OUT
Setting contents: OFF / ON
OFF: Subwoofer output is off.
ON: Subwoofer output is on.

Setting the Digital Output

To connect an audio processor using the optical digital output, set to
"ON" by the following procedure.
Setting item: OPTICAL OUT
Setting contents: OFF / ON
• Afterwards, set ACC to OFF once, then turn it ON again. The setting
of Digital Output is decided.

DISPLAY Setup

Display Setup Operation

The Parking Brake must be engaged to access the DISPLAY
mode screen. Attempting to access this screen while driving will
display the warning-CAN'T OPERATE WHILE DRIVING.
The following steps 1 to 4 are common operations to each
"Setting item" of DISPLAY Setup. Refer to each section for
details.
1
Touch [SETUP] on the main source screen.
The SETUP selection screen is displayed.
2
Touch [ ] of DISPLAY.
The DISPLAY setup screen appears.
3
Touch [ ] or [ ], etc., of the desired item to change
its setting.
Setting items:
TILT* / OPEN/CLOSE* / VISUAL EQ / DIMMER /
DIMMER LOW LEVEL / AUTO BACKGROUND /
BACKGROUND / DATA DOWNLOAD / BASE COLOR /
PULSETOUCH / SCREEN ALIGNMENT
* These functions are adjustable while driving.
4
Touch [RETURN] to return to the previous screen.
• Immediately after changing the settings of Display Mode (While the
system is writing data automatically) do not turn the ignition key
(engine key) to OFF.
Otherwise, the settings may not be changed.

Adjusting the Monitor Angle

Adjust the monitor's angle (between 40 and 105 degrees) for optimum
visibility.
Setting item: TILT
Setting range: 10 adjustable angles are available.
• If the monitor touches an obstacle, remove the obstacle.
• The screen colour will vary when viewed at certain angles. Adjust the
screen angle for the best viewing position.
• If the voltage of the vehicle's battery power is low, the screen may
blink when the screen angle is changed. This is not a malfunction.
39
-EN