Moving The Monitor To Be Flat; Adjusting The Volume; Lowering Volume Quickly; How To View The Display - Alpine IVA-D105R Owner's Manual

Moving the Monitor to be Flat

When you want to operate some function on the car (air conditioner,
etc.) which is hidden by the raised monitor, use this function.
1
When the monitor is open, press OPEN (FLAT).
The monitor moves to the flat position.
2
Press OPEN (FLAT) again.
The monitor returns to the previous angle.
• The monitor returns to the previous angle 10 seconds after being
moved to the flat position.
• If an excessive force is added to the monitor when the monitor is flat,
putting an object on the back of the monitor for example, it may
cause a malfunction.

Adjusting the Volume

Adjust the volume by turning the Rotary encoder.
Volume: 0 - 35

Lowering Volume Quickly

Activating this function will instantly lower the volume level by 20 dB.
Touch and hold the [SETUP] for at least 2 seconds on
the main source screen.
The audio level decreases by about 20 dB.
Touch and hold the [SETUP] for at least 2 seconds on the main
source screen again brings the audio back to its previous level.

How to view the Display

PULSETOUCH operation

The display unit is equipped with onscreen, tactile feedback buttons
(PULSETOUCH).
What is the tactile feedback (PULSETOUCH) ?
When you touch a button graphic in the display, you will feel a
mild vibration and click on the display panel surface. This
feedback enables you to easily identify action areas in the
display.
• To protect the display, touch the onscreen button with the tip of your
finger.
• If you touch a button and there is no reaction, remove your finger
from the display once, and try again.
• If you touch two buttons at the same time, a malfunction may occur.
Onscreen buttons are expressed as follows in this Owner's
Manual.
• Onscreen buttons are shown in bold, enclosed in [ ] (e.g.
[BAND]).

Recalling the Source

Here is an example explanation for the Radio mode display on how to
recall a source.
1
Press SOURCE/ .
The SOURCE selection screen is displayed.
Display example for SOURCE selection screen
Displays source modes that can be selected.
Changes to the Rear Selection screen when "Setting the
Picture/Sound Output" (page 38) is set to ON.
Returns to the previous screen.
• The kind of source modes that are displayed varies depending on
connection and setting
11
-EN