Alpine IVA-D105R Owner's Manual page 68

< JAPANESE CAR >
To install using the vehicle's genuine bracket.
Ground Lead
IVA-D105R
• Make sure to use the supplied flush head screw (M4 × 3) to install
the monitor.
If you use another screw to install the monitor, it may cause a
malfunction. However, only if you cannot install with the flush head
screws (M4 × 3), use the supplied screw (M4 × 6).
Connection Diagram of SPST Switch (Sold Separately)
(If the ACC power supply is not available)
IVA-D105R
• If your vehicle has no ACC power supply, add an SPST (Single-Pole, Single-Throw) switch (sold separately) and fuse (sold separately).
• The diagram and the fuse amperage shown above are in the case when IVA-D105R is used individually.
• If the switched power (ignition) lead of the IVA-D105R is connected directly to the positive (+) post of the vehicle's battery, the IVA-D105R draws
some current (several hundred milliamperes) even when its switch is placed in the OFF position and the battery may be discharged.
To prevent external noise from entering the audio system.
• Locate the unit and route the leads at least 10 cm away from the car harness.
• Keep the battery power leads as far away from other leads as possible.
• Connect the ground lead securely to a bare metal spot (remove any paint, dirt or grease if necessary) of the car chassis.
• If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various
noise suppressors, contact them for further information.
• Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information.
Flush head Screws
(M4 × 3) (Included)
Mounting Bracket
ACC
(Red)
BATTERY
(Yellow)
FUSE (5A)
(Optional)
SPST SW (Optional)
FUSE (20A)
(Optional)
Battery
67
-EN