Setting Of The Rear Camera; Setting Of The External Monitor Output; Setting The Visual Soft Button; Setting The Digital Output - Alpine IVA-W200 Owner's Manual

Setting of the Rear Camera

When the rear camera is connected, rear pictures are output on the
screen.
Setting item: CAMERA IN
Setting contents: OFF / ON
ON: Even if the shift lever is not set to reverse (R), the rear
pictures are output by selecting the CAMERA source.
OFF: The CAMERA source is not displayed on the VISUAL
selection screen.
• By shifting to reverse (R), the rear pictures are output.
This function is effective when the reverse wire is properly connected.
• To apply the setting, set to VISUAL "Setting the VISUAL Soft Button"
(page 35).

Setting of the External Monitor Output

Set it to ON when you use the rear entertainment function (page 25).
Setting items: MONITOR OUT
Setting contents: OFF / ON
ON: By setting the connected external monitor to ON, the
remote control will be usable.
OFF: Remote control operation is not possible.

Setting the VISUAL Soft Button

Setting item: VISUAL KEY
Setting content: VISUAL / NAV.
NAV.: Switches directly to the navigation screen by touching
[VISUAL].
VISUAL: Recalls the VISUAL Select screen by touching
[VISUAL].

Setting the Digital Output

To connect an audio processor using the optical digital output, set to
"ON" by the following procedure.
Setting item: OPTICAL OUT
Setting contents: OFF / ON
• Afterwards, set ACC to OFF once, then turn it ON again. The setting
of Digital Output is decided.

Subwoofer On and Off

Setting item: SUBWOOFER
Setting contents: ON / OFF
ON: Subwoofer output is on.
OFF: Subwoofer output is off.

DISPLAY Setup

Display Setup Operation

To display the Display mode screen:
To watch a video source, your vehicle must be parked with the
ignition key in the ACC or ON position. To do this, follow the
procedure below.
1 Bring your vehicle to a complete stop at a safe
location. Engage the parking brake.
2 Keep pushing the foot brake and release the parking
brake once then engage it again.
3 When the parking brake is engaged for the second
time, release the foot brake.
• For automatic transmission vehicles, place the transmission lever
in the Park position.
Now, the locking system for the Display mode operation has been
released. Engaging the parking brake can reactivate the Display
mode, as long as the car's ignition has not been turned off. It is
not necessary to repeat the above procedure (1 through 3) of "To
display the Display mode screen."
Each time the ignition is turned OFF, perform the procedure of "To
display the Display mode screen."
The following steps 1 to 5 are common operations to each
"Setting item" of DISPLAY Setup. Refer to each section for
details.
1
Touch [SETUP] on the main source screen.
The SETUP selection screen is displayed.
2
Touch [OTHER SETUP].
The OTHER SETUP screen appears.
3
Touch [ ] of DISPLAY SETUP.
The DISPLAY setup screen appears.
4
Touch [ ], [ ] or [OFF], [ON], etc., of the desired
item to change its setting.
Setting items:
DIMMER / DIMMER LOW LEVEL / BACKGROUND / AUTO
BACKGROUND / BASE COLOR / PULSETOUCH / SCREEN
ALIGNMENT
5
Touch [RETURN] to return to the previous screen.
Touch [CONTROL] to return to the main source screen that
was displayed before the setup operation was started.
• Immediately after changing the settings of Display Mode (While the
system is writing data automatically) do not turn the ignition key
(engine key) to OFF. Otherwise, the settings may not be changed.
35
-EN