Wolf Rangetop Service Manual page 8

Component Removal and Installation
4 Wok burner assembly
Remove the Wok Ignitor
1
1 Use a / " socket to remove the wok ignitor mounting
4
screw.
2 Loosen the nut holding the wok ignitor to the tray.
3 Pull the wok ignitor up through the hole in the tray.
4 Disconnect the electrode wire from the wok ignitor.
5 Remove the wok ignitor from the unit.
WOK IGNITOR INSTALLATION
Install the Wok Ignitor
1 Connect the electrode wire to the wok ignitor.
2 Install the wok ignitor into the hole in the tray.
3 Tighten the nut holding the wok ignitor to the tray.
1
4 Use a / " socket to install the wok ignitor mounting screw.
4
WOK IGNITOR ELECTRODE REMOVAL
To remove the wok ignitor electrode, first remove:
Flat wok grate
1
Wok grate
2
Wok top plate
3
Wok burner assembly
4
5 Wok ignitor
Remove the Wok Electrode from the Electrode Mount
1 Remove the retaining nut that holds the electrode into the
electrode mount.
828990 REV. A
Sealed Burner Rangetop with Wok Service Manual
2
WOK IGNITOR ELECTRODE INSTALLATION
Install the Wok Electrode into the Electrode Mount
1
2
WOK TRAY REMOVAL
To remove the wok tray, first remove:
1
2
3
4
5
6
Remove the Wok Tray
1
8
Slide the electrode mount upward and away from the
electrode.
Replace the spring on the new electrode, and slide the
electrode mount onto the ignitor.
Install the retaining nut, and tighten it until it is finger-tight.
Flat wok grate
Wok grate
Wok top plate
Wok frame assembly
Wok burner assembly
Wok ignitor
Use a T-25 Torx bit to remove the screws holding the wok
gas elbow to the wok tray.
service.subzero.com