Power Cord Installation; Regulator Installation; Regulator Removal - Wolf Rangetop Service Manual

Sealed burner rangetop with wo
Table of Contents

Advertisement

Component Removal and Installation
5
Wiring cover
Remove the Power Cord
1
Disconnect the wire leads at the quick disconnect.
2
Remove the power cord wires from the wire retainer.
3
Remove the ground wire screw.
4
Remove the screws holding the power cord access panel to
the burner box.
5
Press the retaining clips on the sides of the strain relief, and
push the strain relief through the power cord access panel
as far as possible. Press on the clip at the front of the strain
relief, and push the strain relief through the power cord
access panel.

POWER CORD INSTALLATION

Install the Power Cord
1
Push the power cord's strain relief through the power cord
access panel.
2
Install the screws holding the power cord access panel to
the burner box.
3
Install the ground wire screw.
4
Place the power cord wires into the wire retainer.
5
Connect the wire leads at the quick disconnect.

REGULATOR REMOVAL

To remove the regulator for a 48" unit, first remove on the right-
hand side:
1
Burner grate
2
Burner caps
Burner assemblies
3
828990 REV. A
Sealed Burner Rangetop with Wok Service
4
Burner pan
To remove the regulator for a 36" unit, first remove:
Flat wok grate
1
Wok grate
2
Wok top plate
3
4
Wok frame assembly
Remove the Regulator
TIP: A red cap on a regulator identifies it as liquid propane (LP).
1
Use a combination wrench to remove the regulator outlet
line from the regulator outlet.
1
2
Use a
/
" nut driver to remove the screws from the
4
regulator bracket.
3
Remove the regulator bracket from the unit.
4
Use two pipe wrenches to remove the regulator from the
inlet pipe.
5
Remove the regulator from the unit.

REGULATOR INSTALLATION

Install the Regulator
WARNING
Use only pipe thread compound. Do not use Teflon
tape to seal gas connections.
1
Use two pipe wrenches to install the regulator onto the inlet
pipe.
2
Place the regulator into the unit.
3
Place the regulator bracket into the unit.
1
4
Use a
/
" nut driver to install the screws into the regulator
4
bracket.
19
Manual
service.subzero.com

Advertisement

Table of Contents
loading

Table of Contents