Side Panel Installation; Side Panel Removal - Wolf Rangetop Service Manual

Component Removal and Installation
REMOVE THE BULLNOSE (continued)
2 Use a T-15 Torx bit to remove the screws holding the
bullnose to the burner box supports.
3 Lift the bullnose off of the screws around the outside of the
burner box.
4 Remove the bullnose from the unit.
BULLNOSE INSTALLATION
Install the Bullnose
1 Set the bullnose onto the unit so that the screws on the
burner box engage with the notches on the edges of the
bullnose.
2 Use a T-15 Torx bit to install the screws holding the bullnose
to the burner box supports.
5
3 Use a / " socket to install the mounting nuts that hold the
16
bullnose PEM studs to the mounting brackets.
TIP: Check for proper alignment of the bullnose before
tightening the nuts.

SIDE PANEL REMOVAL

To remove the side panel, first remove:
Flat wok grate
1
Wok grate
2
3 Wok top plate
Burner grate(s)
4 (one for 36" units, two for 48" units)
5 All burner caps
Uninstall the unit
. Then, remove:
All burner assemblies
1
Burner pan(s)
2 (one for 36" units, two for 48" units)
All knobs
3
All bezels
4
5 Bullnose
828990 REV. A
Sealed Burner Rangetop with Wok Service Manual
Remove the Side Panel
1
2

SIDE PANEL INSTALLATION

Install the Side Panel
1
2
BURNER BOX SUPPORT REMOVAL
To remove the burner box support, first remove:
1
2
3
4
5
6
Uninstall the unit
1
2
3
4
5
6
Remove the Burner Box Support
1
14
Use a Phillips screwdriver to remove the side panel
mounting screws.
Remove the side panel from the unit.
Place the side panel onto the unit.
Use a Phillips screwdriver to install the side panel mounting
screws.
Flat wok grate
Wok grate
Wok top plate
Wok frame assembly
Burner grate(s)
(one for 36" units, two for 48" units)
All burner caps
. Then, remove:
All burner assemblies
Burner pan(s) (one for 36" units, two for 48" units)
All knobs
All bezels
Bullnose
Both side panels
1
Use a / " socket to remove the burner box support
4
mounting screws.
service.subzero.com