Front Perc Module; Removing The Front Perc Module - Dell EMC PowerEdge T550 Installation And Service Manual

Steps
1. Align the fan board tray to the guide pins on the system, slide the tray to the left of the system to lock it in place.
2. Tighten the captive screw to secure the fan board tray to the system.
Figure 41. Installing the fan board tray
Next steps
1. Connect the cables to the fan board.
2. Install the cooling fan cage.
3. Install the air shroud.
4. Follow the procedure listed in

Front PERC module

Removing the front PERC module

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure that is listed in
3. Disconnect all the cables connected to the front PERC module.
Steps
1. Using a Phillips 2 screwdriver, loosen the captive screws on the front PERC module.
2. Slide the front PERC module to disengage from the connector on the drive backplane.
52 Installing and removing system components
After working inside your
Safety instructions.
Before working inside your
system.
system.