Installing The Intrusion Switch Module - Dell EMC PowerEdge T550 Installation And Service Manual

Figure 161. Removing the intrusion switch module
Next steps
Replace the intrusion switch

Installing the intrusion switch module

Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure that is listed in
3. Remove the air shroud.
NOTE: Ensure that you note the routing of the cables as you remove them from the system board. Route the cable
properly when you replace it to prevent the cable from being pinched or crimped.
Steps
1. Align the intrusion switch module with the slot on the system.
2. Slide the intrusion switch module into the slot in the system until firmly seated.
3. Using a Phillips 2 screwdriver, secure the intrusion switch to the system.
4. Connect the intrusion switch cable to the connector on the system board.
module.
Safety instructions.
Before working inside your system.
Installing and removing system components 155