Figure 100. Installing the tape backup unit
Next steps
1. Connect the power cable and the data cable to the tape backup unit.
NOTE:
Route the cables properly to prevent them from being pinched or crimped.
2.
Install the air
shroud.
3. If removed,
install the front
4. Follow the procedure that is listed in
Front IO module
This is a service technician replaceable part only.
Removing the front IO module
Prerequisites
1. Follow the safety guidelines listed in
2. Follow the procedure that is listed in
3.
Remove the air
shroud.
4.
Remove the front
bezel.
5. Disconnect the power and data cables from the front IO module.
NOTE:
The procedure to remove the front IO module is similar for base and upsell configurations.
Steps
Pull the metal release bracket and slide the front IO module towards the front of the system.
bezel.
After working inside your
Safety
instructions.
Before working inside your
system.
system.
Installing and removing system components
105