Table of Contents
Advertisement
4. Raise the collector arm to the highest position and
release the collector lever (Fig. 18). The locking pin
will drop into a hole in the highest position.
5. Pull the collector arm down to raise the back of the
collector (Fig. 18).
6. Close the back of the collector and squeeze the collector
lever (Fig. 18).
7. Lower the collector arm to the working position
(Fig. 18).
Note: Make sure the collector door is fully sealed before
collecting grass.
Figure 18
1. Collector lever
Holding the Collector Door
Open
Warning
Hands, fingers and arms can get pinched between
the back and front sections of the collector.
Keep people away from collector while
emptying it.
If working on the inside, use the holding pin to
hold the collector door open.
1. Disengage the quiet collector PTO control (Fig. 20).
2. Disengage the mower PTO and set the parking brake.
2
1
m-5944
2. Collector arm
12
3. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
4. Open the collector; refer to Opening the Quiet
Collector, page 11.
5. With the collector open, pull out the holding pin and
insert into the hole in the hinge (Fig. 19).
2
3
Figure 19
1. Holding pin
2. Hole in hinge
Changing the Draft Control
The draft control is located on the left side of collector.
There are three positions for the draft control; blow left,
blow right or collecting.
1. To blow right, move the draft control to the lowest
position (Fig. 20).
2. For collecting grass, move the draft control to the
middle position (Fig. 20).
3. To blow left, move the draft control to the highest
position (Fig. 20).
Engaging the Quiet Collector
PTO
The PTO control is located on the left side of collector
(Fig. 20).
1. To engage the collector, move the PTO control to the
upper position. (Fig. 20).
2. To disengage the collector, move the PTO control to the
lowest position (Fig. 20).
1
m-5961
3. Hinge
Advertisement
Table of Contents
