Advertisement
Step 8
S21 ctr
(84)
Each wall panel has a crimped rib
on one side. The crimped rib should
go under the rib of the panel that
follows it.
1
Locate all of the wall panels and
set each one alongside the building.
2
Be sure that you have the correct
panels in each position. Do this by
overlapping the panels and determin-
ing if the holes line up with the holes
in the frame.
3
Fasten the wall panels at the top
and bottom with screws.
4
Fasten the center of each panel to
the wall channel with screws. Fasten
overlapping ribs using a bolt and nut
with two screws.
5
When you have attached all wall
panels in the correct positions, the
building will look like this.
(15)
6515
6515
STEP
Use bolts and
nuts thru wall
angle overlap
at the top of
panel at rear.
Parts Needed For
Wall Panels
STEP
1
Panels rest on
frame as shown
Crimped Rib
Underneath
3
STEP
5
21
6515 Wall Panel (6)
6515
6515
Detail Showing
Center of Panel
Screwed to
Wall Channel
STEP
4
STEP
2
6515
6515
Bolt and nut
does not go thru
wall channel
at overlap
Advertisement
