Advertisement
Step 1
S14 ctr
(8)
The front oor frame is made up of
three pieces. The side floor frames
and the rear floor frame are made
up of two pieces. The holes in these
pieces will align when the pieces are
positioned with correct amount of
overlap. The illustrations below show
the proper overall length for the sides,
rear and front. Proceed as follows:
1
Place the front floor frames as
shown. Center the ramp, with drain
holes facing outside, on top of the two
front oor frames. Join the frames by
inserting eight screws.
2
Overlap the side floor frames
and the rear oor frames as shown.
The holes in these pieces will align
when the pieces are positioned with
correct amount of overlap. See the
illustrations below for the proper
overall length of the side and rear
oor frames. Join the frames by in-
serting ve bolts into each frame set
as shown.
3
Double check the length of each
and set these pieces aside for later
use.
Floor Frame Assemblies
(15)
STEP
1
STEP
2
Parts Needed For
9367
9299
9367
DRAIN HOLES FACE
9299
STEP
3
14
8934 Ramp (1)
9367 Front Floor Frame (2)
8936 Rear Floor Frame (2)
9299 Side Floor Frame (4)
8934
9367
8934
OUTSIDE
Side Floor Frame 112 7/8"
286,7 cm
9299
Rear Floor Frame 119 3/8"
8936
112 7/8" 286,7 cm
119 3/8" 303,2 cm
Front & Rear
119 3/8" 303,2 cm
8936
Front Floor
Frame Assembly
119 3/8" 303,2 cm
9367
303,2 cm
8936
112 7/8" 286,7 cm
Side
Advertisement
