Table of Contents
Advertisement
a. If authentication fails due to an invalid configuration, move the Ethernet cable back to a non-authenticated port
and re-configure the 802.1X settings that confirm to the radius server.
b. A factory reset disables 802.1X and removes all configuration information.
9. The IP-ACM v2 firmware version can be verified by accessing the IP-ACM Status/Control page by entering the IP
address of the IP-ACM into a browser address bar.
Offline configuration
In Offline Mode, there is a limited level of access and control if communication is interrupted between the IP-ACM v2
and the iSTAR. The offline functionality of the IP-ACM v2 allows up to the last 1,000 previous card admits and/or a
specific personnel group of no more than 100. Offline Access stores a set of credentials in non-volatile memory on the
IP- ACM v2. Clearances are not downloaded to the IP-ACM v2 and are not stored.
Refer to the C•CURE Hardware Configuration Guide for more information regarding IP-ACM Offline Mode
Configuration. Offline mode is configured in C•CURE 9000 in the iSTAR Controller editor dialog box in the IP-ACMs
tab.
Card + PIN access is not supported in Offline Mode. Card,-only access with no PIN is supported.
Predefined credentials
Predefined credentials are downloaded from the iSTAR controller in the form of raw data, also called Static Card Data.
When the IP-ACM v2 is offline, access is granted when the predefined credentials, from the Static Card Data stored on
the IP-ACM v2, are presented to the readers.
The following restrictions apply to stored predefined credentials in offline mode:
■ Personnel groups configured for Offline Mode must all share the same card format and facility code.
■ Card formats supported are:
• Wiegand 26
• Wiegand 37
• Two-parity bit style formats
• 32-bit serial number type formats
■ The Offline Mode Personnel Group can only be configured or edited in C•CURE. Offline Mode Personnel Group
changes are sent to the IP-ACM immediately including deleting credentials, if necessary, if the iSTAR controller
and the IP-ACM are online. Any change in the Personnel Group deletes and recreates the IP-ACM static records.
Credentials last granted access
In Offline Mode, the IP-ACM v2 board admits cards that are among the last xxx previous admitted cards in addition to a
pre-defined personnel group.
■ A total of 1000 credentials (not personnel) for both previous admitted credentials and credentials in the personnel
group.
■ Maximum 100 personnel in the personnel group.
■ If you set the Personnel system variable Maximum Cards Per Person, then that value must be taken into
consideration.
16
Hide quick links:
Advertisement
Table of Contents
