Table of Contents
Advertisement
Installing the plastic enclosure and IP-ACM Ethernet Door Module v2
To install the plastic enclosure, complete the following steps:
1. Remove the screws using the Software House security screwdriver (not included, part number: 132-183) and lift
the enclosure cover off of the plastic enclosure.
2. Secure the enclosure to the selected wall or support surface using the holes provided in the enclosure's molded
base. See
Figure 2
It is essential to use all five securing screws when mounting the plastic enclosure. Ensure that the mounting hole at 131.1 across and
NOTE
26.3 up is used as this is required for the "whole unit off the wall" anti-tamper feature to be operational.
3. Remove the IP-ACM v2 from the packaging and place in a safe location using ESD proper procedures while
handling equipment.
4. Secure the IP-ACM v2 to the right of the enclosure.
5. Fit and connect all customer cables. Refer to the power and wiring requirements for more information.
6. Secure the cover with two tamper-proof screws using the Software House security screwdriver.
Metal enclosure
Figure 3
on
Page 8
and
approved for use in a plenum.
Mounting hardware is not included with the metal enclosure. Hardware used for mounting should be able to support four
times the weight of the enclosure not including cabling.
Plastic Enclosure Dimensions
Item
Height
Width
Depth
on
Page 6
for dimensions and hole pitch for mounting.
Table 6
on
Page 7
describe the dimensions of the metal enclosure. The metal enclosure is
Table 6: Metal enclosure dimensions
Metal Enclosure Dimensions
Item
Weight
Height
Width
Depth
Dimension
7.2in (183mm)
12.1in (307mm)
2.46in (62.4mm)
Dimension
~2.6lb (~1.2kg)
8.25in (209.6mm)
7.34in (186.5mm)
3.46in (87.8mm)
7
Hide quick links:
Advertisement
Table of Contents
