System Configuration - Johnson Controls S1-TTSCC01 Installation Manual

11:07AM Thu 21 Jul
Select the desired mode of operation for this device.
Demo Service Tool
Mode
SCREEN 5 - Set Control "Mode"

SYSTEM CONFIGURATION

After selecting the "System Master Mode" button, the Touch Screen Communicating Control will
begin a routine to "discover" system components. The installer will be directed through screens
(Auto Setup) that are dependent upon the system being configured. The below screens will appear
dependent on equipment being installed.
Heat Kit Config
11:07AM Thu 21 Jul
4HK*6500506 4HK*6500806
4HK*6501506 4HK*6501806
4HK*6502506
Heat kit configuration screens will appear in a communication system that includes a communicat-
ing variable speed air handler (indicated by a "-C" in the model number). For the AV/MV Air Handler,
the heat jumper must be located in the "On" position. For more information on the function of these
screens refer to the Service Mode section of this document.
The screen shown above is representative only. Actual heat kit models may vary.
If you have a system which has a heat kit installed, but did not see the heat kit configuration
screens, be sure to check the air handler control to insure that the heat kit jumper is on "Heat".
This only applies to the AV/MV Air Handler.
Johnson Controls Unitary Products
System Master
Mode Mode
4HK*6501006
4HK*6502006
Back
System Master is for installation of a residential
system press.
Demo mode is for use of the Touch Screen Com-
municating Control as a sales or training tool and
will not control a system.
Service Tool Mode is for use of the control to
view operation of a system already being con-
trolled by a Touch Screen Communicating Con-
trol in system master mode.
Heat Kit Config
Selected Heat Kit: 4HK16501506
To select desired heat staging, select desired 1st stage KW:
1st stage heat:
2nd stage heat:
NOTICE
542933-UIM-D-0513
11:07AM Thu 21 Jul
9.6 KW
14.4 KW
Back Accept
17